CAOS Forums

  • October 17, 2017, 07:27:02 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: pulling a notor out of a 2004 ford truck  (Read 65 times)

Keith Lively

  • CAOS Member
  • Registered
  • **
  • Offline Offline
  • Posts: 1524
  • work hard - play harder - build bigger rigs
pulling a notor out of a 2004 ford truck
« on: September 25, 2017, 12:52:28 AM »

I need to pull a cummins ( yes it was swapped in)  out of a 2004 ford truck but don't have a lift to pull the body . Can it be pulled out the front or does anyone know how much a shop would charge for this? there is no AC OR HEAT on the motor.
« Last Edit: September 25, 2017, 09:38:16 PM by Keith Lively »
Logged

yellowyj

  • Registered
  • Offline Offline
  • Posts: 44
Re: pulling a notor out of a 2004 ford truck
« Reply #1 on: September 26, 2017, 10:44:45 PM »

I don't know about that particular truck and motor, but I had a 2000 F250 with the 7.3L swapped out and it came out the front with the cab still in place. The transmission was dropped and the bumper, grill and everything was stripped off the front. A lift was available, but the cab was not pulled. I don't remember the fenders being pulled either, but that was 10-12 years ago.

I have seen a new 6.7L (not mine) come out of a new one the same way (not sure if the trans was dropped or not though) with the cab still on. Fenders were still on it and the transmission was in it when I saw it, but I wasn't there when the motor was pulled or reinstalled.

Not sure if that helps or not since there are some differences in years and motors, but I think it would be possible.
Logged
'01 F250 Lariat Crewcab 4x4, PSD
'91 YJ 4.0, 5sp, Skyjacker Suspension, TJ Flares, 35\" Claws, etc...

Keith Lively

  • CAOS Member
  • Registered
  • **
  • Offline Offline
  • Posts: 1524
  • work hard - play harder - build bigger rigs
Re: pulling a notor out of a 2004 ford truck
« Reply #2 on: October 06, 2017, 06:56:12 AM »

It did come out the front.  I now have a motor for our bus project.
Logged
Pages: [1]   Go Up
 

Page created in 0.069 seconds with 15 queries.